Aspire Spryte AIO Kit

C$--.--
Availability: Out of stock

Another fantastic AIO pod system from Aspire is the Aspire Spryte, a whole new design pod system that is thin and attractive. It is available in five popular, fashionable satin finish colours: olive green, grey, black, blue, and purple. The Spryte contains a 3.5 or 2ml pod that is simple to fill, sits nicely in the hand when in use, and is incredibly unobtrusive. It employs Aspire's well-known BVC coils and comes with a standard 1.8ohm coil as well as a second 1.2ohm coil for usage with nicotine salts.The Aspire Spryte offers a customizable airflow system, which is unusual for an AIO pod device of this sort. The Aspire Spryte atomizer has the well-known and reliable BVC coil, which is made of nichrome wire. The Spryte comes with two coils, one for conventional e-liquid and one for nicotine salts, however it works just as well with standard e-liquid. Whether you use a normal BVC or a nic-salts BVC, both are simple to setup. Simply remove the pod and flip it over, then remove the airflow component and screw in your preferred coil. Replace the associated coil with the airflow component and reinsert it into the pod. Push the pod to the Spryte till it clcks. It is really simple to refill the pod. Remove the pod from the device, invert it, and pull the silicone stopper out of the 4.6mm diameter filling hole. Fill the pod with e-liquid and seal the silicone plug. Push the pod into the gadget until it snaps into place, and it's ready.Remove the pod from the device, invert it, and simply insert the tip of your filling bottle into the 2.8mm diameter spring-loaded filling port. Fill the pod system with your favourite e-liquid by squeezing the filling bottle through the hole. Prior to reducing the pressure on the filling port, relax the pressure on your filling bottle. Replace the pod in the power unit and firmly press down until it snaps into place. It is also incredibly simple to charge the Aspire Spryte. Simply put the included micro USB cable into the mod's base and connect the other end to an appropriate power supply to charge. The maximum charging current can be as high as 1000mA. When connected to the USB and powered on, the LEDs will flash blue and red three times; when completely charged, the LEDs will flash blue and red twenty times before turning off

 

Kit Contents

Standard Version

  • 1* Spryte device
  • 2* Extra O rings
  • 2* coils (1.8Ωregular BVC& 1.2Ωfor Nic Salt)
  • 1* Silicone seal
  • 1* Micro USB Cable
  • 1* Warranty Card
  • 1* User Manual.

TPD Version

  • 1* Spryte device
  • 2* Extra O rings
  • 2* coils (1.8Ωregular BVC& 1.2Ωfor Nic Salt)
  • 1* Micro USB Cable
  • 1* Warranty Card
  • 1* User Manual

 

0 stars based on 0 reviews